The electric stove today is an indispensable element of almost every modern kitchen. With proper maintenance and regular care, it can serve you for many years, of course, if you successfully cope with its connection! It is necessary to approach installation of a plate responsibly.
Connecting a modern electric stove is quite a difficult task, because the manufacturer does not equip electric stoves with an electric cable with a plug, and it is rather difficult for a non-professional to understand his recommendations. The connection of the electric cooker is carried out in various ways, on which the section and brand of cable depend. The cost of electric stoves is quite high for home experiments, so we recommend you use the services of professionals. Call our specialist, he quickly, and most importantly, connect high-quality electric stove, hob, or oven. And also perform various related electrical work , such as moving and replacing sockets, lengthening the wire and replacing the circuit breakers and the RCD in the electrical panel.
The fact is that the connection of electric cookers is the work of an electrician and a good electrician!
The installation of electric stoves, as well as any other electrical equipment of high power, must be carried out in strict accordance with all the rules and regulations envisaged for the installation of various electrical installations. In general , the electrical connection , it is not so difficult if you know where and what to connect.
There is a wiring diagram of an electric stove from which it becomes clear that a wrongly connected stove can fail in one minute!
The connection of the electric cooker is carried out in various ways (single-phase, two-phase and three-phase connection), depending on the type and brand of the electric stove, as well as on your electrical network. Depending on the type of connection, it is necessary to choose a cable with the required number of wires, and conductor cross-sections.
Wiring diagram electric
As a rule, there are several diagrams in the electrical installation manual. How to choose the desired connection scheme? The scheme of connecting modern electric to the electrical network depends on the type of wiring. Almost all electric stoves have a terminal connector, which allows you to connect it to one, two and three phase circuits. Most apartments have a single-phase wiring, therefore the plate must be connected in accordance with the single-phase scheme. To do this, jumpers are installed in the terminal block as shown in the diagram.
To connect the stove, we perform the following actions:
the plate is unpacked and checked for mechanical damage; Requirements for electrical wiring for connecting electric cooker to single-phase line:
After installing the electric cooker and connecting it to the outlet, it is necessary to check the phase between the “ground” and zero phase, the ohmmeter reading should be infinity and 4-10 Ohms, respectively. After that, you can apply voltage to the electric stove. All these operations a person who does not have an idea about the electrics and electricity, will not be able to make an independent installation of the stove . If only because it is fraught with consequences, such as burnout wiring, failure of the plate and even fire and the subsequent fire. Therefore, such work should be entrusted to a qualified electrician installation specialist.
* Built-in hobs and electric ovens are dependent and independent. Their difference in the controls of the electric stove. In dependent sets all the regulators are located on the front panel of the oven. The dependent package has a more complicated wiring diagram. The hob and oven are interconnected by many special connectors.
Before you start using the electric stove, carefully read the instructions.
Что бы оставить комментарий войдите
Комментарии (0)